Mechanical vibration and shock. Evaluation of human exposure to whole-body vibration - General Requirements Ingestion-build-141043

Mechanical vibration and shock. Evaluation of human exposure to whole-body vibration - General Requirements Ingestion-build-1410431 Scope This part of ISO 2631 defines methods for the measurement of periodic, random and transient whole body vibration. It indicates the principal factors that combine to determine the degree to which a vibration exposure will be acceptable. Informative annexes indicate current opinion and provide guidance on the possible effects of vibration on health, comfort and perception and motion sickness. The frequency range considered is 0,5 Hz to 80 Hz for

ISO 17662 is limited to calibration

there may be hundreds of different uses of compressed air

and regarded as not bearing stresses arising from internal pressure

NOTE 1 Requirements and recommendations for software accessibility are specified in ISO 9241-171

Toolmakers' flats are a small precision surface which are ideal for use in inspection and production areas

This document specifies a series of methods for the determination of the ability of a pressure sensitive tape to remain adhered under a constant load applied parallel to the surfaces of the tape and substrate

such as under frequency load shedding (UFLSh)

” “Decohesion test

• emit limited amounts of smoke and corrosive gases when burned as measured by a standard test

1 to 10 MgO 30 to 99

pressed and sintered and metal injection moulded parts such as are listed in IEC 60404-8-9

it is recommended that the selection of the gasket type and materials should be made in consultation with the gasket supplier